I have a 1995 tu150u cyclone in what would appear to be A1 condition. I finally managed to power it up recently, but I got some messages up on the screen. I have the machine. No software, no manuals. What do I need to get going? The 1st image is the message I am getting on the screen and the second,...

Thanks Pete.

Understood. I will check again the 5 wires make sure they are connected correctly.

i have just plugged in Duplex tool post grinder. works ok.

thanks guys. the power supply to the converter is domestic. i understand the earthing system is pms. the guy installing the converter had never heard of pms earthing the new independent trip switch supplying the converter, which powers up fine, has a conventional earthing. i have considered that mix...

Hi Martin, thanks for your interest? I bought a new 10 hp phasewave rotary converter and had this wired into its own power/isolator 140a. The converter Burst into life nicely when switched on. There are 5 wires at the side of the cyclone, conveniently marked L1, L2, L3 etc. the 5 pin plug also has L...

I have had a denford cyclone for 3 years now and not managed to plug it in and get going yes. I got as far as plumbing in a rotary 3phase converter and plugging the machine in to find a dead short. Can anyone help with this installation in the south midlands area. Machine seems to be in a1 condition...

I am being told that i will need the original machine set up. Datum parameters due to the time the machine has been disconnected. Is this the case?

Hi, i have bought a Cyclone. i am after some initial basic information about wiring up (there will be more to follow)? The machine details are as follows:- Serial number :-50911D Dispatch date :- October 1995 Electrics Serial number:- OC0015002 Software version 1.34 I seems to be in near perfect ori...