Search found 6 matches

by v8boy
Sat 25 Aug , 2012 11:19 am
Forum: Novamill
Topic: Connection issue
Replies: 10
Views: 10213

Re: Connection issue

Thanks guys, all sorted now!!!

see you when the next problem occurs!
by v8boy
Thu 23 Aug , 2012 11:55 am
Forum: Novamill
Topic: Connection issue
Replies: 10
Views: 10213

Re: Connection issue

hi there, i am using a male to female RS232 cable with a gender convertor on the end.

Thanks
by v8boy
Thu 23 Aug , 2012 10:11 am
Forum: Novamill
Topic: Connection issue
Replies: 10
Views: 10213

Re: Connection issue

thanks for the advice but there is no improvement.....
by v8boy
Thu 23 Aug , 2012 9:17 am
Forum: Novamill
Topic: Connection issue
Replies: 10
Views: 10213

Re: Connection issue

Hi there, thanks for the advice! Well i have a smartstep card with an upgraded erpom 2.1. In vr milling under RS232 setup i have no option to select which port, the box is blank! Mintman can't find anything, Find machine does not work. So maybe there is a problem with my RS232 port.... maybe this is...
by v8boy
Wed 22 Aug , 2012 17:38 pm
Forum: Novamill
Topic: Connection issue
Replies: 10
Views: 10213

Connection issue

Hi there,

So i have finally managed to get the software to install properly for milling vr 2.31, next problem is that my the software can't find the machine. to get this far i installed a new serial port into the PCI express. any ideas???


Many thanks in advance!

Nic
by v8boy
Wed 22 Aug , 2012 8:21 am
Forum: Novamill
Topic: Help with my new Novamill please
Replies: 2
Views: 4638

Help with my new Novamill please

Hi there everyone, My first post here as yesterday i acquired my Novamill. I have limited experience in using these machines so any help will be greatly appreciated!!!! So.... 1. First on the list as it's been untouched for at least two years is to strip and clean, I know this is fairly straight fo...