Hi ; recently was hand over an triac mill and a orac lathe seem to be working from what I gather. I'm teaching cnc progamming at the college and I think these machine would work good for doing some of the training in the classroom situation. We teach mostly g and m code for programming language and ...

Hi Martin;
I have order a new proximity sensor but will I'm waitng for this is there a way I can have the x axis use the right hand side of the table instead of the left for the datum. It seem with the two limit switch and sensor arrangement it would probably work better that way.
Thanks
Maurice

Good morning;
I have check the Datum and from what I can see if I compare the other two axis ( Z and Y) the X proximity sensor is not sending a single. Which bit is it the first or last one .
Thanks

Hi;
should there be a small block in front of the table that you can adjust lenghtwise ,for specifictly the proximity swicth roughly the same as what you have at each end for the limit travel. Because if there should be one it's not there. I will check that switch.
Thanks

Good Morning;
thanks for the respond. On the main board it's mark TRiac North East Electronics ltd. Serial # 043. We didn't receive any manual with this machine. How can I tell what type of control
Regards
Maurice

Hi ; I'm new at this post so hopefully this will work. We have aquired a used CNC Denford triac CNC mill . we would like to use for demo at the college with our apprentice in the classroom. This machine is fairly old Serial # E02434 July 1985. When we plug it in it required to ABS datum, so it set i...