Interesting! Can you give me instructions for doing so?

Hi, I'm still here...
Ok, the machine works and I have already done some work but when I turn off and turn on does not keep in memory the tool and I have to reset with M27 (RESET CAROUSEL TO POCKET ONE).
The problem was there before the break of Baldor card.
Any ideas?
Thanks again.

YESSSSSS!!!! I did it!
The machine works!
The fault has been an abnormal contact of a fuse on the backplane!
Thank you all for your advice and thanks to Denford for the support.

When i try homing the X axis baldor card writes "H"
When i try homing the Y axis baldor card writes "8"
When i try homing the Z axis baldor card writes "8"

I checked DC on terminals shown on the picture: is not present.
I checked all fuses in the axis card and in backplane: are ok.

the 24volts DC is present on the backplane. wires 60 & 61.
I checked the 3 x 20mm fuses on the backplane and are ok

Eurocard failed probably because I replaced the battery with a wrong.
Before everything was ok just could not remember the tool.
Fuses on the axis cards are ok.

I had already checked, it's ok.
Help please!!!!!

When I try homing, I can turn the X axis leadscrew the motor isn't holding it.
What I do?

I can turn on the coolant.
I can turn the spindle.
But I can not do the homming.

I' ll try tomorrow. I don' t understand ... before BALDOR card should fail everything was ok.

Button ok.

I wanted to try to change the 16 to 12MHz crystal and... It works!!!! YESSSSSS!!!!!
BUT?! It was too good to be true ...
The program starts but when I want to do the zero machine axes do not move.
The tutor works, I access to all menus but axes do not move.

In the old card is installed the type processor KB12 and the silver clock crystal is 12MHz.
In the new card is installed the type processor KB20 and the silver clock crystal is 16MHz.

Exchanging the silver clock crystal from 16MHz to 12MHz this problem is resolved?

I did the test EPROM 2.1 with MintMan.EXE and everything is ok then the RS232 cable from PC to Baldor is correct, right? I have put the old eprom in a new card and the LED light up whith 8. How can I test the old EPROM? How can I test This: esMint, Mint328 EPROM is fitted The new card supports the o...

I still doubt that he spoiled the old card by replacing the battery, it's possible?

Hello, built cable as pattern. We launched the program with this file fanucmd.go: ibm.rs2 1 3F8 $ 4 MACHINE QDENFORD.KBD 1 18.2 0 EGA.CRT 0 FANUCMD.APP I downloaded the file QDENFORD.KBD from your site and I put it in the folder PC always shows the error <50> MINT controller disconnected what advice?

It's so much clearer, I try tomorrow.
Thank you very much.

Thanks but maybe I expressed myself badly.
Mean to the electrical diagram of the cable.
However I did I asked a fellow electrician

I can not understand the pattern of the post.
the image refers to female cable seen from outside.

I tested the COM1 and COM2 on my PC and I am ok.
I put the Machine in COM1 and Tutor in COM2, the same error.
This is the file .go it's ok?

IBM.RS2 2
$3F8 4 MACHINE
DENFORD.KBD 1
18.2 $2F8 3
EGA.CRT 0
FANUCMD.APP

I do not know what to do!
Help me please...