Hi All I have managed to get machine into manual,The door switches were faulty. Still however no movement on anything. When i press the manual buttons the display shows the axis counting up and down but nothing moves. From what i can see the stepper motor drive boards leds are off. is there a fuse f...

Hi Cnc Guru I have had the machine in manual once! but i cant get it into manual again? do i need to press the reset button on the front while pressing x and y axix buttons I have investigated further and found a 7.5 amp fuse on the power board for the spindle motor blown this i replaced but still n...

Hi All I have re soldered some dry joints on the power supply board one on the x axis bridge and the one on the supply fuse, so the question is now all of the leds come on ,on the board to the left when i drop the rear control cabinet cover (The one with the fan on) is the 24v light supposed to go o...

Hi I have checked all of the fuses and they are ok any other advice about voltage detection points on boards or leds on cards, I can hear when i push the green button next to the hand button a high pitch whining.
How do i travel the axis in manual?
Regards
Brian

Hi All I have been given an Orac and i cant get anything to move,The machine turns on with the fan running at the rear and i can hear relays latch in, I have entered the simple program No1 from the manual but nothing happens with the machine however the display scrolls down the programm and shows ax...