Thank you Steve for the photo. Good news is the machine is now working. I followed your latest instructions, both wires looked good and had connectivity. I did notice that the router had stopped close to its limits on the y and z axis, so I manually turned the lead screws to park the router in a bet...

Hi Steve
Thank you for the information. Just to fill in the gaps our machine is from 2009 and Yes the Guard open message comes on and stays on immediately you connect from the software to the machine. Does this give you further clues?
Simon

Hi another guard open problem When the machine is off the door is locked. On switching on the router, the guard open message shows up in the status box in the control panel. When the machine is on I can hear the solenoid working and releasing the door. However, when I try to home the machine the err...

Brilliant, yellow wire disconnected at pin end.
Now repaired and working.
Thank you very much for the prompt advice.

Simon

Hi We have a 2600 pro with 4th axis fitting. Recently the stepper motor on the 4th axis has malfunctioned. Instead of the motor rotating nomally it has started to vibrate back and forth, in an irregular pattern. This happens during a programme and during manual control. I have stripped down the 4th ...

Hi
Many thanks the .eps file seemed to work the best.

Please can you help. I am new to QuickCam 2D Design and I have tried exporting a vector image from Corel Draw X5 into QuickCam. My first attempts, Corel exported as 2008 Autocad dxf file. When importing I could see nothing of the file, even in the preview window. However, when exporting as a Autocad...