Thank you again. :D Interesting stuff! Much reading and pondering to do now. After reading many posts, it looks like getting this controller up & running may be (for me) a bit dodgy. :( I haven't found a thread yet where someone attempted to get a MicroMill running without all the original s/w and a...

Thanks again. I only paid $120 U.S. :D I purchased it from a Craigslist seller who sold it for the man who bought it from the school auction. Apparently it was in storage for quite a few years and the computer, s/w discs & cable were all long gone. Bummer. :cry: So the eprom data for DOS use can be ...

Thanks for the speedy reply! The V2 VR Milling software license code would be available from the main Denford website? I presume it's pretty expensive but would like to know what it would cost before deciding how to proceed. Sounds like the eprom chip decides what kind of s/w will communicate with t...

Good evening gentlemen! I live in Tennessee, USA and recently purchased one of the above-mentioned cute little training mills. The machine itself was used very little and is in like new condition. It is #SP 38556, dated April 1996. The chip on the SmartStep/3 board reads "denmint 2.0.B10/S/B19-JD5" ...