Search found 8 matches

thank you i will take a look at it .

Larry

alan
No i do not have a multimeter, As i do not know much about the electronics side of the machine.
But i found out that the sliding cover operate a cut out switch but these have been removed. I have now replace them and now a new massage, which say's " motor drive fault in x"
When reset and press ...

Dear Alan,

All three LED's light up when switched on.

Regards
Larry

Dear Martin
Would it be possible for me to contact you by phone, As I am not very good on the computer. and would prefare to speak to you direct.

Hi Martin

Yes, the 2+ is a typing error it should be z+.

I have cheeked the fuses looking in side the top and all the green leads are all light

Do you know of anyone near Bedford area, who could up-grade my electronic as I think this would be the best way to solve the problem as it is an old ...

Hi Martin
yes it did display the Diagnostic Screen, this is what came up on screen,
Port Data
Inputs 11111111
Printer 10
Oil Switches 110010
Cassette 0001
M/C Switches 1111
Datums 1100
Step & Dirn 11000000
Drive Faults 1110
O/T'S: -X+, 2+, X-, Z-
Serial link O/C
Dont know if this means ...

yes this is a PNC3 controller,

I tried what you quoted but this did not make any difference.

I don't know much about this machine and how it works as I have only just got the machine.

If anyone can help me I will be grateful, ALso is there anyone in the Bedford area who has the same machine who ...

My Easiturn machine show the following message when i try to switch on "the X movement as exceed its movment". I tried moving my cross silde back to the centre point to see if this would clear the problem but it does not. Therefore can any one help in how to clear this.

thanks
Larry Cheeseman.