Thanks Sir
The Problem is solved
But now i am un able to cut threads.I have tried G33, G76, G92, G76

Dear All I am having a flat bed CNC turning with fanuc ot-d control. The batery of the machine went dead and I had to reload all the parameters and ladder again. Now the machine is up again but when I try to run a program the turret intex and the spindle starts but when G00 comes it does not rapid t...

Sir Thanks for the concern.
Yes sir I have a person who is quite good at it.

Thanks Sir I sent in a mail for the software this was the reply. Yes, i can convert these PMC eprom. But the software is fee software. If you like i can make a demo for you. You can send your 2 chips eprom (27256) in binary code for me. I can convert and then send a part of your PMC ladder program. ...

Sir thanks for the help.
Sir can I get the FA writer and compiler for Faprt ladder I and II.
I will be greatly obliged.
Thanks and Regards

Thank very very much for this help. Sir, I tried to connect via r232 with procomm+ but was unable to do so. Though Ihad made the cable connections correct as per the pin digram at one of the posts in the forum. which I later conformed with a manual I was able to down load from the net. Also I want t...

Hi
I purchased a flat bed kirloskar with fanuc otd control.
It did not have a MPG now I want to put an mpg on the machine for which i need the circuit digram.
Any help will be appriciated.