I've gotta smartstep3 controller, DenMint

7-seg is dsplaying a blinking dot, and an L ".L" (dot is blinking)

What the heck does that mean?

THanks
Brian

Hello all, Recently we acquired a Denford MicroMill Integrator (similar to the MicroMill 2000). It was in a non-working condition and after some consideration we've decided to remove the Sherline Mill from the denford enclosure and scrap both the enclosure and the electronics. We tried to evaluate t...

Is that VR milling V2 software downloadable/usable off the denford website.. I did not receive any software with the system, so I don't have a license file and will obviously not be able to test or even fix this machine.. Maybe since it's no longer supported, maybe you guys could work with me on a c...

The Yellow tape label has the following: denMINT 2.0.B10/S/B19-JD5 Bar Code (board) OC00193067 The main driver board, says SMARTSTEP/3 (OC00197356) The main driver board has 8 orange screw terminal/connectors (if that helps ya) There's also another third card that sits above the main board, and the ...

Can't tell you what's on that label yet - I haven't received the mill yet - should be coming in today or tomorrow. I'll let you know and again thanks for the quick replies.

Brian

thanks for your reply, I've included some photos of the system.

I purchased a used Denford MicroMill "Integrator" and I don't think it's coming with software, and the condition of this thing (working?) is questionable - how do you recommend me testing this thing(the electronics)??? And, could anyone give me a good summary as far as what software I need to use th...