Hi,

Checked the spindle motor it has SEM on the side name plate the stall torque on the plate is 4.5NM, difficult to see anything else due to its position.
If this is the problem is there a retro-fit up grade, and what will it cost?

Regards Bid

Hi guys, Can anyone help, I'm trying to rigid tap M8x1.25 on the above machine all seems ok when cutting fresh air, as soon as I try to tap the steel component the machine spindle stops turning and pushes the tap up inside its ER32 collet until it reverses. Program: Speed is S100 M03 Feed is G94 Can...

Hi :? I'm new to Fanuc, so bare with me! I can get the above machine to run simple programs. but I cannot get it to zero datum from the bottom left of the component. I drive the tool to the required point and follow the instruction as per the book using G90 G91 G92 codes, I expected the tool to them...

Many thanks for the drive board manual, the electronics guys are checking things.
I will let you know how they get on etc, and whether it rectifies the fault.
Regards
paul

Hi again, :oops: The spindle drive board we think is causing the problem is a CT1 9852 or sprint 1600i, the machine is a 2001 vintage. The two LED lights in the top left hand corner of the board are both on, but the same fault remains. Is there a printed circuit board drawing/diagram for this drive ...

Hi, The two power LED's both light up on the spindle drive board, and there is 24volts going into the drive motor, but the same "1004 fault" remains. The spindle turns freely by hand, and all axis drives move in Jog and Home using the control panel, F3 fuse is also ok. Is there an electrical drawing...

Hi everyone, I have just been given a TRIAC- FANUC ATC milling machine by a local college to use as a training aid for apprentices. It had a few faults but was in good condition and seemed to be worth investing in, these faults have all been rectified except one. The error code says: 1004 SPINDLE DR...