I download the mint then break out if it. Prior to giving commands, the controller card reads 8. After giving commands, I get, "card aborted on axis2" after that, the controller card reads E until I power off and back on. The spindle drive board doesn't have any removable fuses that I see, all the m...

After trying many combinations of commands, no motion from the mill yet. Some of the syntax in mintman is "Card aborted on axis 2", then P> seems to be after anything I enter. THe number on the controller is 3 while I am communicating with it. Is this normal? I haven't been able to locate a manual f...

I have already installed VR Milling V.5.26 and am running the mintman.exe file from that. It is better to use the older version for some reason?

I am following the steps in this post trying to test a used micromill 2000 with a denstep controller. So far I have established a good connection but having a lack of MINT code knowledge, don't know any INIT or MOVE commands that ozofnash spoke of. I am assuming these are entered into the command li...