(I will give some details)
-Windows 10 operating system
-Work Bench / Build number: 5860
-Servo drive. FMH 2A06TR-EN23
-Servo motor. BSM 80N-375 AF
Mint workbench informs that the motor encoder is not supported by the controller. I also fail
Feedbact test. In jog, the motor runs irregularly at lower revs, an overload fault occurs.
Overload error is very common. Status Led 8 or 5
I would like to ask for help and advice.
What firmware and how to properly upload it to the controller. I will provide more specific details when making contact.
- is it the fault of the wrong software
- 20210214_145019~2.jpg (692.36 KiB) Viewed 5878 times
- 20210218_190238.jpg (153.66 KiB) Viewed 5878 times
- 20210218_190356.jpg (595.52 KiB) Viewed 5878 times
- should I ignore this message
- Inked20210213_104442_LI.jpg (1.01 MiB) Viewed 5878 times