F1 car machined right>left NOT left<right
In the tutorial supplied with QuickCAM PRO it tells me to set the raster angle to 90
When I do, the cuts are generated from RIGHT (X+) to LEFT (X-) and not the other way round as in the tutorial
This is only a problem when I'm making a car that will break off the right hand side on the final few passes.
F1 car machined right>left NOT left<right
Moderators: Martin, Steve, Mr Magoo
- Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
- Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact: