floating point division by zero

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

floating point division by zero

Post by Benny » Tue 28 Oct , 2008 13:02 pm

NOVAMILL ATC Circa 2002

Customer recently downloaded VR CNC Miling V. 2.31. Software and manufacturing runs fine. One small problem is 1) run a part it works perfect. 2) run the 3-D simulation it runs perfect. 3) try to have the 3-D simulation run at the same time the part is running get an error message dialog box: floating point division by zero. Customer has turned down the hardware acceleration but message still pops up.
The message does not affect or stop manufacturing. It just becomes annoying because when you turn it off it comes back on several times during the course of the program.

Any ideas?
Top
User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Tue 28 Oct , 2008 16:03 pm

Thats a strange one and would probably take a bit of finding - seeing as the program works fine when only outputting to one or the other.
I can try it in V5 to see if it happens there as well - as we can't support the V2 milling code any longer.
Top
Post Reply

Return to “VR Milling - All Versions”