Some instructions here (thanks to enny):
How to operate a Clarkson Autolock chuck
Moderators: Martin, Steve, Mr Magoo
- Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
- Roy
- CNC Expert
- Posts: 104
- Joined: Tue 30 Jan , 2007 20:20 pm
- Hardware/Software: 1986 Triac modified & running Mach 3
- Location: Bucks, UK
Re: How to operate a Clarkson Autolock chuck
I think that should be thanks to RoyDenford Admin wrote:Some instructions here (thanks to enny):
- Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
-
- CNC Guru
- Posts: 396
- Joined: Mon 20 Nov , 2006 18:19 pm
- Hardware/Software: 280 VS lathe, Denford Senior E-type mill, Senior Major Universal Mill
- Location: East Midlands, UK
Clarkson Autolock chuck catalogue
Some more Clarkson information - shows chuck sizes and collet designations / part numbers.
Andy
Andy
- Attachments
-
- Clarkson chucks and collets.pdf
- Extract from Clarkson catalogue
- (1.44 MiB) Downloaded 2592 times