Viceroy T.D.S 1/1 G.B - All finished

Read what other Denford users are doing with their machines and software.
Educational resources, ideas and courseware.
If you have a Denford related success story, please tell us about it here.

Moderators: Martin, Steve, Mr Magoo

Hans
Posts: 2
Joined: Tue 07 Nov , 2017 9:16 am

Re: Viceroy T.D.S 1/1 G.B - All finished

Post by Hans » Tue 07 Nov , 2017 14:56 pm

Thanks Dazz,

I'm abroad at the moment, so will check this our when I'm home

Pzy
Posts: 27
Joined: Mon 26 Aug , 2019 8:10 am
Hardware/Software: Denford Viceroy TDS1/2P.C.S Metric
Ajax AJ8 horizontal milling machine
Q&S 6H power hacksaw

Re: Viceroy T.D.S 1/1 G.B - All finished

Post by Pzy » Sat 09 Nov , 2019 12:05 pm

dazz wrote:
Thu 22 Jul , 2010 12:07 pm
Hello

No I didn't find a reference to adjust the bearing pre-load. I devised my own method which is documented on another topic. The worst you can do is wreck the bearings. They are used on Cessna undercarriage and are readily available in Akld.

The lathe came with an extra cross slide with Tee slots. It looks a lot like the Myford version. It is not as big as the Denford boring table, but entirely adequate.



Regards

Dazz
Hello, Daz. Do you have any photos of the "extra cross slide" in place / in use? I'm unsure how this would work and would be interested to see. Many thanks.

User avatar
dazz
CNC Expert
CNC Expert
Posts: 243
Joined: Sat 19 Aug , 2006 11:31 am
Hardware/Software: Viceroy TDS 1/1GB lathe, Imperial, stripped down and rebuilt.
Viceroy Taper/Tracer attachment, Shop made cross slide tracer attachment, VSD.
Location: New Zealand

Re: Viceroy T.D.S 1/1 G.B - All finished

Post by dazz » Sun 10 Nov , 2019 18:32 pm

Hi
The extra cross slide is just a copy of the factory one but with Tee slots. It is a lot like a Myford version but scaled up. Nothing special.
I have never had it mounted on the lathe. Never needed to use it.
Regards

Dazz

Post Reply