Text/ buttons are not shown or pushed out of the window

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Mr Magoo, Martin, bradders, Steve

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3589
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Text/ buttons are not shown or pushed out of the window

Post by Denford Admin » Wed 30 Oct , 2013 16:57 pm

In some software, for instance the Control Panel in VR Milling, it is possible for some of the text in the window or buttons to be not shown because they are pushed off the borders of the window. For instance:
controlpanel.JPG
controlpanel.JPG (29.06 KiB) Viewed 2348 times
This is because Window's DPI setting will be a value greater than 100 %. The text is increased in size and any components are moved to compensate, but the windows themselves are not resized.

To resolve this in Windows XP, right click on the desktop and select Properties from the following menu. Next choose the Settings tab and then click the Advanced button. On the next screen, set the resolution to be 100%.
screenResolutionChange.JPG
screenResolutionChange.JPG (14.79 KiB) Viewed 2350 times
To resolve the issue on Windows 8, rightclick on the desktop. Select Screen Resolution from the drop-down menu.

Select 'Make text and other items larger or smaller'.
windows8resize.jpg
windows8resize.jpg (51.5 KiB) Viewed 2346 times
Select the text box marked Smaller - 100%.

Post Reply