MILLCAM \ LATHECAM DESIGNER I get a "No G code generat

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

MILLCAM \ LATHECAM DESIGNER I get a "No G code generat

Post by bradders » Thu 16 Mar , 2006 12:22 pm

Q.When using MILLCAM \ LATHECAM DESIGNER I get a "No G code generator" displayed when the software starts.
Last edited by bradders on Thu 16 Mar , 2006 12:26 pm, edited 1 time in total.
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Thu 16 Mar , 2006 12:25 pm

You need to check that the maximum time must exceed the time needed to machine (Alt and S keys in the design screen).

If you still get the same message then there is probably no Dongle or Flash code present and MCD\ LCD goes into Demo mode i.e. No G code generator”
Top
Post Reply

Return to “Software”