Does Denford software work with Windows Vista or Windows 7?

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Does Denford software work with Windows Vista or Windows 7?

Post by Denford Admin » Mon 12 Feb , 2007 11:33 am

Image
Does it all still work on Windows Vista ?
Last edited by Denford Admin on Mon 12 Feb , 2007 11:44 am, edited 2 times in total.

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Mon 12 Feb , 2007 11:41 am

We have done some test with Vista - all of our current products work fine :D

See the current table here:

http://website.denford.ltd.uk/support/8 ... a-win7-art


Older software such as MillCAM designer which was written around the time of Windows 95, will not install - we didn't spend much time trying to get the old things working, so there may be a few tips and tricks to getting 16 bit applications to run.

If anyone has got old Denford (or related) software working on Vista then let us know how you got on.

Post Reply