Denford software supported operating systems

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

Denford software supported operating systems

Post by bradders » Fri 03 Mar , 2006 12:48 pm

Any idea what operating systems are supported by Denford software :?:

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Fri 10 Mar , 2006 15:16 pm

VR Milling 5 will only run USB link on Win2K, XP or higher-will work fine on older OS if using RS232 link to the machine

All others like QuickCAM 2D Design will run on any windows OS - Win95/98 may need windows installer updates

(This is a list for older software)
Image

Post Reply