Triac Fanuc OM-C Drip Feed

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Mr Magoo, Martin, bradders, Steve

Post Reply
Tomalexander
Posts: 2
Joined: Mon 18 Feb , 2019 10:08 am
Hardware/Software: 1993 trial atc

Triac Fanuc OM-C Drip Feed

Post by Tomalexander » Thu 18 Apr , 2019 2:58 am

Hi All,
I have a 1993 Triac ATC with a Fanuc OM-C Controller and i would like to enable drip feeding.

i can send programs either way from an RS232 cable, but i seem to have a very limited memory, my controller is telling me i only have 4095 i assume bites, apparently the machine had a memory upgrade but i had to re enter the parameters after loosing them so the extra memory may not be enabled.

I have looked in the ladder and i do have G127.5 but i dont have a tape switch, i can find lots of info about changing Diagnostics and parameters to enable drip feeding, there seems to be lots of different ways to do it i am just not sure what way to go.

any help would be much appreciated.

cheers,
Tom

Post Reply