altering feed and speed in auto mode VR Milling 2.16

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Mr Magoo, Martin, bradders, Steve

Post Reply
Akorenika
Posts: 3
Joined: Mon 19 Feb , 2018 20:46 pm
Hardware/Software: Novamill VR milling version 2

altering feed and speed in auto mode VR Milling 2.16

Post by Akorenika » Mon 19 Feb , 2018 21:17 pm

Hi, I have a Novamill without the Feed and Speed override knobs fitted to the machine. I use VR Milling version 2.16 and in Auto mode the I can't alter Feed and Speed at all. They are set at 75% and 85% respectively. Is there a way to get the sliders or F5 to F8 buttons working? Alternatively how can I fit physical override pots? Any help would be greatly appreciated.

Regards

Adrian

Martin
CNC Guru
CNC Guru
Posts: 1605
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: altering feed and speed in auto mode VR Milling 2.16

Post by Martin » Tue 20 Feb , 2018 0:03 am

If you disconnect from the machine then go in to Setup Machine arameters (password is denny) the machine capability then untick both the feed & spindle override pots.

Akorenika
Posts: 3
Joined: Mon 19 Feb , 2018 20:46 pm
Hardware/Software: Novamill VR milling version 2

Re: altering feed and speed in auto mode VR Milling 2.16

Post by Akorenika » Tue 20 Feb , 2018 1:07 am

Much obliged

Regards Adrian

Post Reply