Password for toolbar layout change?

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
slickmcvic
Posts: 7
Joined: Fri 24 Nov , 2017 10:04 am
Hardware/Software: Denford Microrouter Compact 4th axis 2005

Password for toolbar layout change?

Post by slickmcvic » Fri 24 Nov , 2017 11:52 am

Hi,
I've just commandeered a MRC with VR Milling software.
I was following a few steps relating to the setup of the software however when I attempted to change the toolbar change the toolbar layout I was met with a password request.
I contacted the previous owner who had no recollection of changing or adding a password and cant find where to resest it.
Any Ideas!
Thanks

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Password for toolbar layout change?

Post by Martin » Fri 24 Nov , 2017 16:54 pm

Our usual password is denny but it may be that you are seeing a read/write computer access password which would more due account settings on the computer.

slickmcvic
Posts: 7
Joined: Fri 24 Nov , 2017 10:04 am
Hardware/Software: Denford Microrouter Compact 4th axis 2005

Re: Password for toolbar layout change?

Post by slickmcvic » Mon 27 Nov , 2017 0:23 am

Cheers,
It easy Denny alright,found it in relation to a feed pot error on this forum
Thanks!

Post Reply