Page 1 of 1

Password for toolbar layout change?

Posted: Fri 24 Nov , 2017 11:52 am
by slickmcvic
Hi,
I've just commandeered a MRC with VR Milling software.
I was following a few steps relating to the setup of the software however when I attempted to change the toolbar change the toolbar layout I was met with a password request.
I contacted the previous owner who had no recollection of changing or adding a password and cant find where to resest it.
Any Ideas!
Thanks

Re: Password for toolbar layout change?

Posted: Fri 24 Nov , 2017 16:54 pm
by Martin
Our usual password is denny but it may be that you are seeing a read/write computer access password which would more due account settings on the computer.

Re: Password for toolbar layout change?

Posted: Mon 27 Nov , 2017 0:23 am
by slickmcvic
Cheers,
It easy Denny alright,found it in relation to a feed pot error on this forum
Thanks!