VR milling 2 - z plane arcs
Posted: Mon 06 Nov , 2017 14:23 pm
Hi Folks,
I'm using fusion 360 for cam which is going pretty well. However some of the linking paths via the denford post use g18/19 plane arcs moves. My novamill doesn't like these, I'm using the official denford post. My mill is rs232 red segment controller and latest VR Milling 2 software. Is it just that g18/19 plane moves aren't supported?
Any thoughts would be much appreciated.
Many thanks
Barry M
I'm using fusion 360 for cam which is going pretty well. However some of the linking paths via the denford post use g18/19 plane arcs moves. My novamill doesn't like these, I'm using the official denford post. My mill is rs232 red segment controller and latest VR Milling 2 software. Is it just that g18/19 plane moves aren't supported?
Any thoughts would be much appreciated.
Many thanks
Barry M