VR milling 2 - z plane arcs

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Mr Magoo, Martin, bradders, Steve

Post Reply
bpmsl
CNC Expert
CNC Expert
Posts: 141
Joined: Mon 16 Nov , 2009 10:00 am

VR milling 2 - z plane arcs

Post by bpmsl » Mon 06 Nov , 2017 14:23 pm

Hi Folks,
I'm using fusion 360 for cam which is going pretty well. However some of the linking paths via the denford post use g18/19 plane arcs moves. My novamill doesn't like these, I'm using the official denford post. My mill is rs232 red segment controller and latest VR Milling 2 software. Is it just that g18/19 plane moves aren't supported?

Any thoughts would be much appreciated.
Many thanks
Barry M

Post Reply