Denford Software & Machines

Posted: **Mon 06 Nov , 2017 14:12 pm**

Hi folks, I'm now using my novamill more frequently and one of the things that's annoying (from a surface finish perspective) is that the mill doesn't execute consecutive lines of code as a continuous path. The mill stops at the end of each gcode line / move before continuing on to executing the next. Is this normal for the controller (red segment rs232 and latest vr milling 2)? If not is there a setting in th software I need to change?
Any thoughts would be much appreciated.
Many thanks
Barry M

Posted: **Mon 06 Nov , 2017 15:22 pm**

Have you tried running with Turbo switched on?

Posted: **Mon 06 Nov , 2017 16:08 pm**

Martin wrote:Have you tried running with Turbo switched on?

TURBO! That sounds like a good setting to me... I'll have a look tonight.

Thanks Martin...

Posted: **Mon 06 Nov , 2017 20:21 pm**

Martin wrote:Have you tried running with Turbo switched on?

Many thanks Martin just the ticket!

Denford Software & Machines

VR milling 2 - continuous tool paths?

VR milling 2 - continuous tool paths?

Re: VR milling 2 - continuous tool paths?

Re: VR milling 2 - continuous tool paths?

Re: VR milling 2 - continuous tool paths?