Autodesk Fusion 360 - Denford Post
Posted: Sat 29 Oct , 2016 19:15 pm
Hi Folks,
I'm running a Novaturn + Toolchange with DOS FLSTEP and a Novamill with Win 2K VR Milling v2.32, is the Denford post processor option in Autodesk Fusion 360 fully compatible?
As always any help would be much appreciated.
Cheers
BPM
I'm running a Novaturn + Toolchange with DOS FLSTEP and a Novamill with Win 2K VR Milling v2.32, is the Denford post processor option in Autodesk Fusion 360 fully compatible?
As always any help would be much appreciated.
Cheers
BPM