Print feature, config denford easiturn text editor

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
techy
Posts: 30
Joined: Mon 12 May , 2008 14:00 pm

Print feature, config denford easiturn text editor

Post by techy » Wed 11 May , 2016 14:20 pm

We have an easiturn lathe and programmed it successfully through the denford text editor software, the print option in the dos screen had an option to save as a lst file or print, print did not function but we were able to save a lst file which we could print through notepad.
The hard disc died and I have reinstalled the software on a new disc, Unfortunately I cannot remember where this option is located, also whilst the baud rates, parity settings etc have been retained successfully, again where is this facility located.
Thanks in anticipation
Techy

Post Reply