Cyclone tu150u. What do I need to get started

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
makman
Posts: 8
Joined: Tue 01 Jan , 2013 8:44 am
Hardware/Software: denford Triac (easicnc), Denford Cyclone (tutor)

Cyclone tu150u. What do I need to get started

Post by makman » Sun 24 Aug , 2014 18:14 pm

I have a 1995 tu150u cyclone in what would appear to be A1 condition. I finally managed to power it up recently, but I got some messages up on the screen. I have the machine. No software, no manuals. What do I need to get going? The 1st image is the message I am getting on the screen and the second, the spec of the machine. Can you advise what I need. It has the original tutor software.
image.jpg
image.jpg (72.71 KiB) Viewed 4920 times
image.jpg
image.jpg (73.54 KiB) Viewed 4920 times
Attachments
image.jpg
image.jpg (605.29 KiB) Viewed 4920 times

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Cyclone tu150u. What do I need to get started

Post by Martin » Mon 25 Aug , 2014 19:32 pm

The TU15U requires a 3. 1/2" system disc in the floppy drive on the side of the electrical box. It would be easier if you can locate the original floppy disc, otherwise you will need to create a bootable floppy & install the TU150U software which can be downloaded from the Dos software section on the Denford website.

Post Reply