Customer writes...........
In FANUCMD DOS software
when I type a line of code. (N110 G90 G00 X10 Y10 Z-1 )
It comes up with a error that says. Prefixes not needed and the cursor high lights on the G of G00
FANUCMD DOS software - Prefixes not needed
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: FANUCMD DOS software - Prefixes not needed
I don't know how many G codes could be programmed on a single line in the DOS software - the current windows software only supports three IIRC
It'll be worth separating every G Code onto it's own line
It'll be worth separating every G Code onto it's own line