can you convert dos to v5 milling

norm · Post by **norm** » Wed 13 Feb , 2013 23:00 pm

new cnc. ive been reading the forum for a few days now.trying find out how to get some information on starmill. running on dos no luck up to now
the problem all i get initialising mint3.28. it starmill seriel no 30217 a march1993

Martin · Post by **Martin** » Wed 13 Feb , 2013 23:16 pm

What version is the Eprom?

norm · Post by **norm** » Wed 13 Feb , 2013 23:28 pm

what is eprom

Martin · Post by **Martin** » Wed 13 Feb , 2013 23:37 pm

The Eprom is the chip on the baldor control board inside the electrical cabinet.

norm · Post by **norm** » Thu 14 Feb , 2013 0:08 am

the only chip i can see mint/3 282

norm · Post by **norm** » Thu 14 Feb , 2013 0:24 am

ive been looking again mint 3/282 vi.05/s/kc.16 i think have been looking at the right part

Martin · Post by **Martin** » Thu 14 Feb , 2013 17:58 pm

Ok, So it is a Dos chip,

It would upgrade to VRMilling but you would have to contact Sales for a price.

Have you looked through other posts on the forum.

From memory you may need to run through dosbox if it is a fairly new Windows operating sytem.

Denford Software & Machines

Denford Software & Machines

can you convert dos to v5 milling

can you convert dos to v5 milling

Re: can you convert dos to v5 milling

Re: can you convert dos to v5 milling

Re: can you convert dos to v5 milling

Re: can you convert dos to v5 milling

Re: can you convert dos to v5 milling

Re: can you convert dos to v5 milling