Error code on CONECT 250

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
o1543andy
Posts: 10
Joined: Tue 23 Aug , 2011 19:44 pm
Hardware/Software: Conect Numerical control 250 machine
Denford VR CNC Milling software

Error code on CONECT 250

Post by o1543andy » Tue 23 Aug , 2011 20:40 pm

Hi there , i'm very new to this cnc so please bare with me .
I have a conect 250 cnc router date of manufacture is 1998 , when i try to put it into machine mode i get this code

Access violation at address 005BA3BA in module windmill.exe. Read of address 0000000

The software is denford v 2.29
The machine is a large bench top type with a ally cabinet around it e stop button and so on .

Like i say i'm very green so to speak so any help at all will be great , thanks Andy

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: error code

Post by Denford Admin » Wed 24 Aug , 2011 15:40 pm

First thing is to double check the dongle rights as mentioned in another reply.
Then check you have the correct machine selected in VR milling - if not:
Choose menu Setup > Setup machine parameters > password: denny
Then right-click on CONECT250 on the tree view on the left, then choose Set As Active machine.
Whilst in parameters, also check that the ComPort under the communications section is correct - ie is the machine plugged into COM port #1 or #2 etc..

Post Reply