Power saving settings for USB machines and Win7

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Steve, Mr Magoo, Martin, bradders

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3588
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Power saving settings for USB machines and Win7

Post by Denford Admin » Thu 23 Jun , 2011 13:39 pm

This document shows you how to alter the power saving settings on Windows 7.
Adjust the settings for reliable USB communication between PC and Mill, Lathe, Laser or rapid prototyping machine
Try this if you find the machine times out or you get timeout messages after a certain time - you're more likely to see it on a laptop or "green" desktop
Attachments
PowerSettingsWin7.pdf
(982.86 KiB) Downloaded 1219 times

pennygosling
Posts: 3
Joined: Fri 15 May , 2015 2:30 am
Hardware/Software: Hi

I am running a VLS 3.5 with extraction unit below. The extraction unit has started to make a strange sound about 30 seconds after it is turned on. It sounds as though an internal fan is catching on something inside the casing. After looking the the maintainence manual I am none the wiser about how to tackle this problem. The filters do not yet need replacing.

Any suggestions would be greatly appreciated.

Thanks

Re: Power saving settings for USB machines and Win7

Post by pennygosling » Mon 30 Nov , 2015 4:00 am

I tried altering the power settings but the same issue arises. The machine is disconnecting before starting to cut.

Could the firm ware need updating to communicate with windows 8? which is running on a macbook.

The machine works ok with windows 7 on a Dell machine.

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1261
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: Power saving settings for USB machines and Win7

Post by Steve » Mon 30 Nov , 2015 7:15 am

Is this on a laser?

Are you using a laptop, if so is the power supply plugged in?

Have you tried other USB ports on the computer?

The USB port you are using is probably not providing enough power to the machine. You may need to use a powered USB hub.

Post Reply