DOS software Fanucl , Fanucld , Fanucsld etc.

[bradders]

What old DOS software do I use with my machine ?

[bradders]

Fanucl DOS Lathe software Qwerty keyboard
Fanucld DOS Lathe software Desk Top Tutor
Fanucsld DOS Lathe software Specific to GSM Starturn

Fanucm DOS Mill software Qwerty keyboard
Fanucmd DOS Mill software Desk Top Tutor
Fanucsmd DOS Mill software Specific to NEE Starmill

In the go file
DENFORD1.KBD 1 refers to the new Tutor with changeable overlays
DENFORD.KBD 1 refers to the old tutor with fixed overlays
QDENFORD.KBD 1

[alphaindustry]

Hi!
I' have a denford starturn 4 and I have bought it 4 months ago but I dont have any driver for it.
Can you provide me a registered driver which is compatible with my Starturn 4.

[bpmsl]

hi, is there any way to get the dos sw running without being connected to my novaturn? It'd be nice to have the option to run simulations in the house rather than the garage.
Any help appreciated.
Ta
barry m

[Denford Admin]

The DOS software is now free but not supported by Denford - the flash codes remove the need for a dongle, and can be found here (flashes.txt):
http://www.denford.ltd.uk/index.php?opt ... &Itemid=51

I understand there were different versions of the DOS s/w - some for the machines and some for offline use.

[bpmsl]

For the record it seems that with FLSTEP you can get the SW running connected to a novamill, then turn off the mill and as long as you dont switch to a machine control mode the SW will run fine.

Cheers
BPM