PRO/Desktop Error The command has been aborted.

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

PRO/Desktop Error The command has been aborted.

Post by Steve » Fri 13 Nov , 2009 11:55 am

Hello

I am trying to install PTC Pro/DESKTOP 8 on Dell Optiplex 745’s with Window XP the program opens up, but when you go to File, new , design , we get the error message….. “The command has been aborted. An internal error occurred in Pro/DESKTOP. It is most likely that doing the same thing will produce the same error.” I tried reinstalling the program without success.. Please advise

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: PRO/Desktop Error The command has been aborted.

Post by Steve » Fri 13 Nov , 2009 11:56 am

The problem is probably with the graphics card on the PC.

Open the software

Go to the Tools Menu

Select Options

Select performance

Then check the box that says Disable Graphics Hardware Acceleration (slower)


It should now work
:D

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: PRO/Desktop Error The command has been aborted.

Post by Steve » Fri 13 Nov , 2009 11:57 am

Hello

That fixed the problem… Thank you very much

Post Reply