problems with registration disc

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
3d worker
Posts: 21
Joined: Mon 19 Oct , 2009 9:41 am

problems with registration disc

Post by 3d worker » Thu 22 Oct , 2009 9:31 am

Hi again,
Yesterday when I went to click on the VR milling icon it asked me to register it, I had with the floppy in the past. I went through the upgrade reg. process and put in the floppy. It found the sec. file but then kept saying not registered and terminating. Im using V5. Can you help.
Thanks

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: problems with registration disc

Post by Denford Admin » Thu 22 Oct , 2009 9:36 am

Try using regrights - see the last post in this thread:
viewtopic.php?f=8&t=2321

User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

Re: problems with registration disc

Post by bradders » Thu 22 Oct , 2009 10:18 am

Because, on all the Denford latest types software i.e. VR Milling, VR Turning, Quickcam Pro etc, the security codes all have the same file name i.e. SecKey.tff. If you use Regrights it will tell you what Denford software the SecKey.tff is registered for and the number of licence(s)

Post Reply