Disabling the Upgrade button on new Denford software

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Steve, Mr Magoo, Martin, bradders

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3588
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Disabling the Upgrade button on new Denford software

Post by Denford Admin » Tue 21 Jul , 2009 14:38 pm

All Denford software released on or after 21st July 2009 will have the facility to disable the Flash license Upgrade button.
If the following file exists in the program's main directory, then the button will not be shown.
DisableFlashUpgrade.txt
eg, for VR Milling v5, just create a new text file in the directory: C:\Program Files\Denford\VRMilling5 and rename it DisableFlashUpgrade.txt
This feature was requested by a school that had trouble with students clicking upgrade when the software ran and wasting lots of time.

Post Reply