Convert .jpg to .dxf

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
BuckeyeSupport
Posts: 4
Joined: Mon 18 May , 2009 16:17 pm
Location: Lexington, OH
Contact:

Convert .jpg to .dxf

Post by BuckeyeSupport » Mon 18 May , 2009 16:28 pm

Anyone know how to do this? I can't figure it out reading the Tutorial on QuickCAM 3D.

I attached the .jpg file I would like converted.

Thanks,
Kristina
Attachments
02_Bulldog.jpg
02_Bulldog.jpg (98.24 KiB) Viewed 3215 times

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Thu 28 May , 2009 16:38 pm

Hi - you can't do that in QuickCAM 3D - only in QuickCAM 2D

There's an example here:
viewtopic.php?t=1062

Post Reply