Starturn 4 BBC Software

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
rob
Posts: 9
Joined: Tue 05 Dec , 2006 13:18 pm
Location: Powys

Starturn 4 BBC Software

Post by rob » Thu 07 May , 2009 1:25 am

Hi,
I have recently aquired a Starturn 4, it runs off a BBC. I was wondering if anyone out there had software, and lead connection wiring diagram. My intention is to try to get it going, just to see what it was like.
I currently have a Starturn 5, and an Orac which I am in the process of converting to Mach.
So if anyone can help with the Starturn 4, I would be ever so gratefull.

Regards,
Rob.

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Thu 07 May , 2009 8:56 am

Did it come with the original BBC computer ?
If not then you may struggle - I believe there was an interface card or eeprom or something like that, which had to be installed into the BBC.

http://www.industrycommunity.com/manufa ... ges/3.html

Post Reply