Artcam and Roland Machines

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Artcam and Roland Machines

Post by Benny » Mon 28 Apr , 2008 15:53 pm

Is there an Artcam post for a Roland MDX -20.

Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Artcam and Roland Machines

Post by Benny » Mon 28 Apr , 2008 15:54 pm

ArtCAM has several post processors for the Roland machines. I have been told that sometimes getting the software to communicate with the Roland's can be a bit of a challenge and a trial and error thing. The first post processor to start out trying inside ArtCAM would be - RolandMDX1520.con. Delcam has had success with several MDX-20's using ArtCAM so it shouldn't be too big a deal.

Post Reply