Autocad Questions
Posted: Mon 21 Apr , 2008 14:13 pm
Using ACAD 2007 LT
I have tried DWG and DFX.
The VR Milling v5.13 software recognizes the file, but I cannot select the units.
If I switch from the simulator to the mill - "Exceeds Limits" error appears.
If I go from the mill to the the simulator - "Radius Error" or "Out of Limits"
Also, does PRZ have to be set Every time you start a program?
Any suggestions.
I have tried DWG and DFX.
The VR Milling v5.13 software recognizes the file, but I cannot select the units.
If I switch from the simulator to the mill - "Exceeds Limits" error appears.
If I go from the mill to the the simulator - "Radius Error" or "Out of Limits"
Also, does PRZ have to be set Every time you start a program?
Any suggestions.