We have a problem with our 3 Mirac machines. The spindle will not run
on any of them - this is a bit odd! Machines are free standing and not
on a network.
Spindle speed is shown as zero when we try to start spindle. I can only
assume that there is a setting that may have been changed by someone.
Can you help resolve this?
No spindle Speed on Reinstalled DOS V 1.42. Mirac PC's
Moderators: Martin, Steve, Mr Magoo
- bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
No spindle Speed on Reinstalled DOS V 1.42. Mirac PC's
Last edited by bradders on Mon 10 Dec , 2007 9:33 am, edited 1 time in total.
- bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
The answer to your Qs are as follows:
1. Can you tell me what machines you have?
MIRAC PCs
2. Has the software been reinstalled recently ?
NO - THE MACHINES HAVE BEEN WORKING NORMALLY
3. Is there speed override know on the machines ?
YES - SPINDLE SPEED OVER RIDE
4. are they turned up ?
YES - THE PROBLEM IS ON ALL THREE MACHINES AND THIS HAS BEEN CHECKED.
5. What version of Denford software are your running to control the machines ?
MIRAC STEPPER V1.42
1. Can you tell me what machines you have?
MIRAC PCs
2. Has the software been reinstalled recently ?
NO - THE MACHINES HAVE BEEN WORKING NORMALLY
3. Is there speed override know on the machines ?
YES - SPINDLE SPEED OVER RIDE
4. are they turned up ?
YES - THE PROBLEM IS ON ALL THREE MACHINES AND THIS HAS BEEN CHECKED.
5. What version of Denford software are your running to control the machines ?
MIRAC STEPPER V1.42