Hi,
I've just commandeered a MRC with VR Milling software.
I was following a few steps relating to the setup of the software however when I attempted to change the toolbar change the toolbar layout I was met with a password request.
I contacted the previous owner who had no recollection of changing or adding a password and cant find where to resest it.
Any Ideas!
Thanks
Password for toolbar layout change?
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 7
- Joined: Fri 24 Nov , 2017 10:04 am
- Hardware/Software: Denford Microrouter Compact 4th axis 2005
Re: Password for toolbar layout change?
Our usual password is denny but it may be that you are seeing a read/write computer access password which would more due account settings on the computer.
-
- Posts: 7
- Joined: Fri 24 Nov , 2017 10:04 am
- Hardware/Software: Denford Microrouter Compact 4th axis 2005
Re: Password for toolbar layout change?
Cheers,
It easy Denny alright,found it in relation to a feed pot error on this forum
Thanks!
It easy Denny alright,found it in relation to a feed pot error on this forum
Thanks!