Hi All,

I bought an Easimill 3 not long back, originally intending to convert to EMC2.

However I found it was so convenient to have a machine with a stand alone controller that I have left it as is for now.

The problem I was left with was that the legacy Denford DNC software only ran on Win98 or DOS and it hung on uploads between lines anyway.

I can't stand Windoze, so I have written a small Linux QT application which uploads and downloads files quickly and simply.

It is posted here for free download by anyone who wants it.



There is a basic README file with it.
To download you simply open the required file, put PNC3 into receive mode and press the Send button. You will get a success message or the error number and line it occurred on.
To upload, put PNC3 into transmit mode and press the Receive button.

There is no drip facility, because I simply would not use it.
I tend to make heavy use of the G81 repeat loops for incremental cutting and seldom find a program goes beyond 20 lines.

I use it daily and hope it will be useful to others. Might wean a few off Gate's wares.

regards

ArcEye

PS. Have updated the files to allow larger files to be downloaded, see README file

Thanks for sharing this