VR Turning Demo version - (not current)

Help and advice for Denfords lathe control software VR Turning.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

VR Turning Demo version - (not current)

Post by Denford Admin » Wed 11 Apr , 2007 10:52 am

Here is a demonstration version of VR Turning which was built some years ago, however, it still gives an idea of the softwares abilities:

http://www.denfordata.com/downloads/VRTurning-Demo.zip (7.6 Mb zip file)

giovaime
Posts: 3
Joined: Wed 11 Apr , 2007 0:24 am

Type in Editor

Post by giovaime » Wed 11 Apr , 2007 18:50 pm

In demo version i can´t write in editor box.

I have to do a leason in piece of wood, i wrote my codes G e M..

i want to test and see if work´s my codes.

It´s possible in demo version?

Tanks.

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: VR Turning Demo version - (not current)

Post by Denford Admin » Fri 10 Jun , 2011 9:25 am

I have found another old demo of Milling (v2) and Turning - I think (ie I haven't tried them) these demos will let you edit and simulate the G Code (up to something like 30 lines of code)

http://www.denfordata.com/downloads/MillTurnDemoOld.zip (23 Mb zip file)

Post Reply