Page 1 of 1

G71 Type 2

Posted: Thu 15 Oct , 2020 11:51 am
by rs-tackle
Hello, I would like to run the following program code but the machine does not run like I know it from Fanuc the contour is exactly the same when roughing half the contour is turned awake how can you solve that?

G0 Z2
G0 X42
G71 U1. R0.5
G71 P10 Q19 U0.5 W.1 F0.27
N10 G42 G01 X0 Z1 F0.18
G1 Z0
G3 x6 z-.5 r.5
g2x7.723 z-19.235 r70
g2x9.071 z-20.413 r2
g3x14. z-25.745 r7
g3x8 z-31.49 r7
N19 G40 G01 X42
G0 X45 Z2