Cyclone P

Help and advice for Denfords lathe control software VR Turning.

Moderators: Steve, Mr Magoo, Martin, bradders

Post Reply
sukyme
Posts: 7
Joined: Fri 14 Jul , 2006 4:39 am
Location: Malaysia
Contact:

Cyclone P

Post by sukyme » Mon 17 Jul , 2006 1:34 am

We are going to use Brass for our next project. Please give your advice the setting that should we set to machine. i.e spindle speed, speed ..etc
260699

User avatar
Denford Admin
Site Admin
Posts: 3588
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Wed 19 Jul , 2006 22:48 pm

Sorry - it looks like no-one is going to answer !

Here are my thoughts:

Picking the correct feeds and speeds is a bit of a "black art" - I would go for the highest spindle speed you can (4000RPM?), and experiment a bit with the feedrate - program say 200mm/min and the feed override (0 to 150%) will give a good range to speed it up or slow it down.

The surface finish and chipping ability will also depend on how deep your cuts are and the type of tool tip your using

The only way to find out what works best is to give it a try on some old brass bar


Hope this helps in some way :wink:

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1261
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Post by Steve » Thu 20 Jul , 2006 13:21 pm

I agree, you probably want to set the spindle speed in manual mode to full speed (4000) then take some manual cuts. Roughing should be good at 2-3mm depth (Diameter) then set the feed to about 600mm/ min and turn down the feed override. Take a cut and turn up the override untill adjust the feedrate untillyou get a good cut. Record the value and then use that in program.


There is a document on the US website

http://www.denford.com/USAHOME.htm

Go to SUPPORT then FEEDS & SPEEDS.

This covers milling feeds and speeds but is relevant

Post Reply