NAN in the axis-lines after try homing

Help and advice for Denfords lathe control software VR Turning.

Moderators: Martin, Steve, Mr Magoo

Post Reply
Lilly of the valley
Posts: 1
Joined: Fri 15 Jan , 2010 15:15 pm

NAN in the axis-lines after try homing

Post by Lilly of the valley » Fri 15 Jan , 2010 16:06 pm

Hi folks!
I have a probleme with my Microturn 2000NS / VR Turning v1.22

I was just running a very simple file and it worked out fine. Then i shut down the PC to see if it still works after restarting everything. Well it didn´t :(

The folloing Problem occured:
When I tried to Home the machine, it made a real bad sound and vibrations. The machine controll window showed "NAN" in both Axis-lines and Feed was set to 0%

When I checked the work piece offsets in the current offset for X and Z Offset the Distance to origin field showed "NAN" as well.

Restarting everything again and choosing different offsets couldn´t fix the problem. I´ve also checked the manual feedrate knop - it´s stillin it´s position. The VR Machine still works fine.



Thanks for any help.

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: NAN in the axis-lines after try homing

Post by Denford Admin » Fri 15 Jan , 2010 17:01 pm

I think this will be the problem: viewtopic.php?f=2&t=54&hilit=nan

(Regional settings using comma , for fractions instead of a decimal point .)

Post Reply